Wednesday, February 26, 2014

Ge gas water heater warranty

GE gas water heater warranty


I bought a GE gas water heater model PG40S09AVG00 from Home Depot in Dec 2006. I paid for an extended service contract through Dec. 2022.Recently I tried to drain some water at the bottom of the tank to get rid of sediments. I got half a bucket, but the 2nd time I when I turned on the faucet, no water came out. I gave it several turns to no avail. I tried this several times. When turning the knob it makes a funny sound. I called GE at 1-800-431-1549 on 10/22/08. I was told that they could not find a service Company in my area which is Elmont NY 11003. They will call me back, I waited 2 days and called again. they said that they are still looking. On 10/29/08 I called again and was told they can't find anyone to service the water tank. I contacted Home Depot at 800-437-3783 Option 1 and got a helpful representative. After she contacted GE I got a call back from Home Depot explaining that I would have to find my own repair service, pay for it and then be reimbursed by GE. She gave me their tel. # I contacted their Customer Care department. They verified what Home Depot had told me. They gave me a case # and a FAX # where to mail the bill up to $250. Above this I have to get an OK before the repair is made. GE Custome Care # 1-800-793-3768. FAX # 1-877-763-3006 I can't help with warranty service, they will switch you to someone elese until you stop calling. But you may have a large buildup of sediment, which has blocked the drain spout. That can usually be cleared with a coat hanger, but the water is HOT, so you will need hand protection for when the water starts to flow. Relieve the pressure in the tank by turning off the water supply(and turn off power or gas), at the water inlet or the house supply. Then open the safety valve on the side at the top of the tank(with something to catch the water). Open the drain valve, with something under to catch the water, or a floor drain. With a coat hanger or piece of thin wire, probe the open valve. You should begin to get some flow, which may stop and start, more probing until you get continuous flow. Once flow is established, let it run until the debris has cleared. Reset everything and you should be OK. The drain valve is plastic, so there may now be scratches on the ball valve and you may get drips. A catch pan may be needed. But flush the heater 2-3 times a year and you will likely get much better than average life from it. Frankly, these days the warranty on almost anything is nearly a joke. On things that need on site service, when you are in a rural area that often compounds things. It seems that although you had to go through quite a bit of red tape, they have gone the distance in ultimately honoring your warranty in the best way they can. The alternative at some point will be to give you a whole new tank , but they will try to avoid that if at all possible. This is why for most things I basically opt for self-insured, because my cynical nature tells me that any supposed warranty may be science fiction.








Related Posts:




  • Installing indirect water heater

    Installing Indirect water heaterI have a SuperStor 40 Gal Indirect water heater it's 7 years old and may be starting to leak (it's up on blocks and I see a water stain every 3 or 4 days, in one co...


  • Expansion tank needed on hot water heater

    Expansion tank needed on hot water heater?So i'm looking to replace the current hot water heater and noticed that an expansion tank is recommended...but is it needed if there's no check valve or b...


  • Is this water pressure gauge and can i replace it myself

    Is this water pressure gauge and can I replace it myselfAO Smith Gas Water heater - Model: FSG 75 250, 74 Gallon. I think it's about 10 yrs old. I found the attached analog needle gauge that is no...


  • Hot water heater wont stay lit

    Hot Water Heater Won't Stay LitI recently purchased a house that had been empty for a while, among the many other problems the Kenmore hot water heater will not stay lit. Service men from sears ha...


  • Help replacing thermocouple on ge gas water heater gg38t06axk00

    Help replacing thermocouple on GE gas water heater, GG38T06AXK00Our hot water went out 2 days ago. The water heater was replaced 2 years ago, and it's been trouble-free the entire time. I've never...